The collet and collet body hold the tungsten in place and need to match its diameter exactly. A worn or incorrectly sized collet allows the tungsten to shift slightly during welding, which affects arc stability in ways that are easy to blame on technique when the actual cause is a consumable that needs replacing. CK Worldwide and Furick are two of the ranges we stock here, and these are inexpensive parts, but neglected ones cause a disproportionate amount of frustration at the torch.
TIG welding relies on a handful of small consumable parts inside the torch that have an outsized effect on how the arc behaves. The tungsten electrode itself doesn't melt into the weld; it simply carries the arc, and different tungsten types, distinguished by their alloying elements, suit different current types and materials. Getting the wrong tungsten for the job typically shows up as arc wander or poor arc starts long before it shows up anywhere else.
Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.
Surface flatness and tolerance are the starting point, but fixturing is what turns a flat plate into a genuinely useful tool. Tables with a grid of holes or T-slots let you bolt down clamps, stops and jigs in repeatable positions, which speeds up repetitive fabrication and makes it far easier to hold parts square while tacking. A table without any fixturing options usually ends up needing extra clamps, magnets or improvised supports to achieve the same result.
Matching duty cycle to actual workload, rather than just chasing the highest amperage figure, is the difference between a machine that keeps up with the job and one that keeps tripping out halfway through it, and it's a question worth raising with a supplier before you buy, such as
https://wikifad.francelafleur.com/Utilisateur:GlenJewell1619.
Space and power supply are the other two practical constraints worth checking early. Confirming that a chosen machine will run comfortably from the electrical supply actually available in the workshop, and that there's room to work safely around it with materials laid out, avoids the common mistake of buying a machine that then can't be used the way it was intended.
