Budget for a first machine is rarely just the welder itself. A gas cylinder and regulator for MIG or TIG, a decent auto-darkening helmet, gloves and
recommended site basic workshop ventilation all add to the real cost of getting started, and skimping on the supporting equipment tends to cost more in frustration than it saves in cash. It's worth pricing the whole set-up before settling on a machine at the top of the budget.
A reliable, adequately sized compressed air supply is the part most first-time buyers underestimate. Undersized or contaminated air, whether from moisture, oil or an undersized compressor, is one of the most common causes of poor cut quality and shortened consumable life, so it's worth checking a machine's air requirements against what your compressor can actually deliver before you buy, not after.
A gas lens sits in place of the standard collet body and uses a fine mesh to straighten the shielding gas flow into a smoother, more laminar stream around the arc. This generally allows a longer stick-out from the cup without turbulence pulling in surrounding air, which is particularly useful when working in tighter joints or awkward positions where the torch needs to sit further back from the work.
Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.
The practical difference comes down to what a machine can draw and sustain. A single-phase supply has a ceiling on how much continuous power it can deliver before tripping breakers or overloading domestic wiring, which is why the highest-output welding and cutting equipment is frequently three-phase only, or offers noticeably better duty cycle performance when run on three-phase. For workshops without an existing three-phase supply, bringing one in usually means an electrician and, in some cases, an application to the local distribution network operator.
A welding table is easy to overlook when planning a workshop, yet a poor one undermines accuracy on every job that touches it. If the surface isn't flat, nothing clamped or squared against it will be either, and small errors compound quickly on anything with multiple joints or angles.
