Most domestic UK properties are supplied with single-phase power, typically 230V, which is more than adequate for light-duty inverter welders used for hobby work, repairs and general fabrication. Three-phase supply, commonly 400V to 415V across three live conductors, is standard in industrial premises and delivers power more efficiently to heavier equipment, which is why higher-output welders and
plasma cutters, including some Fronius and ESAB machines, are often offered in a three-phase version.
A reliable, adequately sized compressed air supply is the part most first-time buyers underestimate. Undersized or contaminated air, whether from moisture, oil or an undersized compressor, is one of the most common causes of poor cut quality and shortened consumable life, so it's worth checking a machine's air requirements against what your compressor can actually deliver before you buy, not after.
If you're not sure which supply a particular machine needs or whether your workshop can support it, it's a sensible question to put to a supplier before ordering, and the team at welding fume extraction can talk through the options against your existing set-up.
Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.
Getting the air supply, cutting capacity and portability right for your workshop is easier with some guidance up front, and that's the kind of buying question the team at MIG welders UK are set up to help with.
MIG (metal inert gas) welding feeds a continuous wire electrode through a gun, shielded by a gas supply, which makes it fast and relatively forgiving for general fabrication, sheet steel and repair work. Jasic's MIG range is one of the more popular starting points here, covering entry-level compact units through to higher-output machines as work scales up. TIG (tungsten inert gas) uses a non-consumable tungsten electrode with a separate filler rod, giving a slower but tidier result that's favoured for thinner materials, aluminium and stainless steel where finish quality matters. MMA, or stick welding, strikes an arc from a flux-coated electrode and needs no shielding gas at all, which makes it the most portable option and a common choice for outdoor or on-site work on thicker steel.
