Every workshop is different, so rather than relying on general advice, it's worth getting your own set-up properly assessed. A system that works well for one shop can be quite wrong for another with different ventilation, floor space or process mix, and an on-torch extraction option, such as those available for Fronius torches, suits a different layout to a fixed overhead hood.
Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.
Keeping a stock of the right tungsten types, collets and gas lens sizes for the work you do avoids a lot of avoidable downtime, and it's the sort of consumables range worth sourcing from a specialist supplier like welding helmets and PPE.
Most people buying their first welder get stuck at the same fork in the road:
Tec Products Thirsk MIG, TIG or MMA. Each process strikes an arc differently and suits a different type of work, so the right choice depends more on what you'll be building than on which machine looks the most impressive on a shelf.
Shade range and sensor count are the two specifications that matter most in daily use. A wider variable shade range lets one helmet cover a broader spread of processes and amperages, from low-amp TIG work through to higher-output MIG or MMA, without swapping cartridges. More sensors generally mean the filter is less likely to miss a low-angle arc or a strike caught at an awkward viewing angle, which matters most for TIG welding where the arc can be harder for a sensor to pick up cleanly.
Buying a first welder is easy to overthink. Rather than starting from a shortlist of machines, it helps to start from the work: what materials, what thickness, and how much of it will be done indoors versus outside or on-site. That single question narrows the choice between MIG, TIG and MMA far more usefully than comparing spec sheets in isolation, whether you end up looking at a Jasic entry-level MIG package or something further up the range.
